1932 Austin American Bantum Hot Rod Custom Streetrod Car 12 valve Cummins Diesel for sale

1932 Austin American Bantum Hot Rod Custom Stree rod Clastic Car 12 valve Cummins Diesel

Available is a one-off custom build! Lots of love and money have been poured into this car.

Its a 1932 American Austin Bantum steel body. This is an Authentic steel two door coupe, Bantum Body with Green Metal Flake and NO rust.

The body was chopped and channeled and the frame was hand built on a fame table.

Rear end is a ford 9 inch with posi. Wheels are hurst cheater slicks DOT approved.

Wheel base is about 125 inches.

Body dimensions about 45” high, 48’ wide and 60” long. At its lowest point its about 3 inches off the ground. Just high enough to clear speed bumps.

Drives great, easily can get it up to to 80 MPH, no vibration or sketchy feel.

Engine is the infamous 12 valve cummins 5.9 Diesel with 47RH tranny. I have gone through it and replaced all front and rear seals.

Wired in the center is the TC lockup and overdrive. Has a 15 gal tank.

I am 6’2” 225 lbs and can fit, but it is tight! If you are looking for leg room this is not a Cadillac.

I sit up just fine in it to see out, its the leg room that is rough if you are driving longer then 45 min.

I built the car and drove it daily to work and back, weather got hot so I parked it in the garage and it has been sitting for the past 2 years, with an occasional drive here and there. This was my 7th custom build car and I am currently on my 9th build. I build, drive, sell and start another project.

I just cringe at the thought of selling this one, it was just such a unicorn build. You will never see another one like it.

It has never been to a car show and these are the first photos that are being posted on my car. Im a very private individual. I love car shows but Im not the guy who likes to sit and talk about my stuff…